Tuesday, 22 March 2011
New cover for my homemade ironing board!
This is one of the most useful gadgets that I have and I made it myself!
Its my mini ironing board that I use to shape my applique flowers and leaves etc, its also useful when I'm piecing blocks.
It is 14 inches square (but can be made any size) and I needed to give it a fresh cover as it had scorch marks on it and was starting to look a bit grubby.
To make one for yourself (go on you know you want to!)
You need a small thin piece of wood (mine is about 1cm thick )
Cover it with wadding, I used a spray baste to hold it in place (if you don't have any, just carefully align it on the material, then lay the wood on top
Lay it batting side down onto the material
Fold the material over itself, so you don't have raw edges, then fold over the wood and staple it down at the centres
On the corners, to avoid a build up of material , cut away a small piece
If you are very thrifty you can save this bit of material for your scraps collection
Then tuck in the corner and fold over
Make a neat corner, spend ages on this bit and strive for perfection
Pop in a staple to hold
Carry on all the way round, making sure the material in taut and flat (Don't go flabby on me)
Use a hammer to finish burying the staples into the wood and fabric, check for any sharp edges that could scratch your work table
If you need to, you could glue a piece of batting or fabric over the staples.
This is my finished board, ready for action
I used a spring loaded stapler and a hammer (I can't accept any liability if you are a fool with a tool no compensation will be paid)
Posted by happydaysquilting at Tuesday, March 22, 2011